FX3U-32MT-DSS PLC 24V DC 16DI 16DO Transistor Mitsubishi with Programing Cable

FX3U-32MT-DSS Mitsubishi PLC Base Unit Original Brand NEW

General Specifications [Main Unit]

Item	Ambient temperature
Ambient temperature	0 to 55°C (32 to 131°F) when operating and -25 to 75°C (-13 to 167°F) when stored
Ambient humidity	5 to 95%RH (no condensation) when operating
Vibration resistance	Conforms to EN 68-2-6
		Frequency (Hz)	Acceleration (m/s 2 )		Half amplitude (mm)	Sweep Count for X, Y, Z: 10 times (80 min in each direction)
	When installed on DIN rail	10 to 57	--		0.035
		57 to 150	4.9		--
	When installed directly	10 to 57	--		0.075
		57 to 150	9.8		--
Shock resistance	Compliant with EN 68-2-27 (147 m/s2Acceleration, Action time: 11ms, 3 times by half-sine pulse in each direction X, Y, and Z)
Noise resistance	By noise simulator at noise voltage of 1,000 Vp-p, noise width of 1 µs, rise time of 1 ns and period of 30 to 100 Hz
Dielectric withstand voltage*1	1.5kV AC for one minute			Compliant with JEM-1021 Between each terminals*1 and ground terminal
	500V AC for one minute
Insulation resistance*1	5MΩ or more by 500V DC megge
Grounding	Class D grounding (grounding resistance: 100  Ω or less) system is not allowed.>*2
Working atmosphere	Free from corrosive or flammable gas and excessive conductive dusts
Working altitude	Compliant with IEC61131-2 (<2000m)*3

*1

Terminal	Dielectric strength	Insulation resistance
Between power supply terminal (AC power) and ground terminal	1.5 kV AC for one minute	5MΩ or more by 500V DC megger
Between power supply terminal (DC power) and ground terminal	500V AC for one minute
Between input terminal (24V DC) and ground terminal	500V AC for one minute
Between output terminal (relay) and ground terminal	1.5 kV AC for one minute
Between output terminal (transistor) and ground terminal	500V AC for one minute

For dielectric with stand voltage test and insulationresistance test of each product, refer to the following manual.

→ Refer to FX3U Series User's Manual - Hardware Edition.

*2 For common grounding, refer to section 3.3.

*3 The PLC cannot be used at a pressure higher than the atmospheric pressure to avoid damage.