FX0N-32NT-DP Mitsubishi PLC Profibus-DP Interface Unit Original Brand New

FX0N-32NT-DP Mitsubishi PLC Profibus-DP Interface Unit Original Brand New  

 

FX0N-32NT-DP Mitsubishi PLC Profibus-DP Interface Unit Original Brand New

Introduction

This FX0N-32NT-DP Profibus-DP Interface Unit (called “32NT-DP” hereinafter) can be used as a slave module to connect an FX0N, FX1N, FX2N or FX2NC*1series programmable controllers (called “PLC” hereinafter) to an existing Profibus-DP network. The 32NT-DP provides an intelligent slave function for decentralized control applications which need to exchange data with Profibus-DP master CPUs (called “DP-master” hereinafter).

*1 when using an FX2NC series PLC, an FX2NC-CNV-IF is required.

Features of the 32NT-DP

By using the 32NT-DP the PLC can exchange data with any DP-master.

• The default settings allow to send 16 words and to receive 16 words of data in one

communication cycle. These values can be adjusted between four word and 20 words ofsent and received data.

• The communication between the PLC main unit and the internal buffer memory of 32NT-DPis handled by FROM/TO instructions.

• The 32NT-DP occupies 8 I/O points on the PLC’s expansion bus. The 8 points can beallocated from either inputs or outputs.

• The 32NT-DP can be connected to a Profibus-DP network by a standard 9-pin D-SUB connector and a shielded twisted pair cable complying with EN50170. Optional glassfiber adapters are supported by the 32NT-DP and are available from other vendors.

General Specifications

Item	Specification
General specifications (excluding withstand voltage)	Same as those for connecting PLC
Withstand voltage	500V AC for 1 minute (between terminals and earth)

Power Supply Specifications

Item	Specifications
Power supply	24V DC +/- 10%, 20mA (when using a twisted-pair cable) / 60mA (when using a optical glassfiber cable)
Interface power supply	5V DC, 170mA (internal power supply from PLC)

Dimension