CPM2A-40CDR-A PLC New in box

CPM2A-40CDR-A Omron PLC New in box

Omron PLC CPM2A-40CDR-A

Product Description?

Functions as a slave for Device Net.

Equipped with 32 input points and 32 output points for I/O exchange with the master.

International standards: UL, CSA, CE.

Features:

Item		CPU Units with 20 I/O points	CPU Units with 30 I/O points	CPU Units with 40 I/O points	CPU Units with 60 I/O points
Supply voltagepp y g	AC power	100 to 240 VAC, 50/60 Hz
	DC power	24 VDC
Operating voltagep g g range	AC power	85 to 264 VAC
	DC power	20.4 to 26.4 VDC
Power consumptionp	AC power	60 VA max.
	DC power	20 W max. (See separate table following this one for details.)
Inrush current	AC power	60 A max.
	DC power	20 A max.
External power supply (AC power supplies (AC power supplies only)	Supply voltage	24 VDC
	Output capacity	300 mA (See notes 1, 2, 3.)
Insulation resistance		20 M? min. (at 500 VDC) between the external AC terminals and protective earth terminals
Dielectric strength		2,300 VAC 50/60 Hz for 1 min between the external AC and protective earth termi­nals, leakage current: 10 mA max.
Noise immunity		Conforms to IEC61000-4-4, 2 kV (power lines)
Vibration resistance		10 to 57 Hz, 0.075-mm amplitude, 57 to 150 Hz, acceleration: 9.8 m/s2 in X, Y, and Z directions for 80 minutes each (Time coefficient; 8 minutes × coefficient factor 10 = total time 80 minutes)
Shock resistance		147 m/s2 three times each in X, Y, and Z directions
Ambient temperature		Operating: 0° to 55°C Storage: –20° to 75°C
Humidity		10% to 90% (with no condensation)
Atmosphere		Must be free from corrosive gas
Terminal screw size		M3
Power interrupt time		AC power supply: 10 ms min. DC power supply: 2 ms min.
CPU Unit weightg	AC power	650 g max.	700 g max.	800 g max.	1,000 g max.
	DC power	550 g max.	600 g max.	700 g max.	900 g max.

Note:

1. Use the external power supply as the power supply for input devices only. (It cannot be used as to drive output devices.)

2. If the external power supply current exceeds the rated current, or there is a short-circuit, the external power supply voltage will drop and PC operation will stop.

3. If there are 3 CPM1A-MAD11 Units mounted to a CPM2A-60CDR-A, the current for the external power supply must not exceed 200 mA.