ASD-B2-0421-B Detla AC Sevor Drive 1ph 220V 400W 2.6A New

ASD-B2-0421-B Detla AC Sevor Drive 1ph 220V 400W 2.6A New

Drive Specifications

Model				ASD-B2-0421-B
Product Name				AC SERVO Drive
Corresponding Servo Motor				ECMA-C*0604?S (S = 14mm) ECMA-C*0604?H (H = high inertia) ECMA-CM0604PS (S = 14mm) ECMA-C*0804?7 (7 = 14mm) ECMA-E*1305?S (S = 22mm) ECMA-G*1303?S (S = 22mm)
Series				ASD-B2
Rated Power				400W
Power Supply	Phase / Voltage			Single-phase: 200 ~ 255VAC, 50/60Hz ±5%
	Continuous Output Current			2.6 Arms
Cooling method				Natural Air Circulation
Encoder Resolution /Feedback Resolution				17-bit (160000 p/rev)
Main Circuit Control				SVPWM Control
Tuning Modes				Auto/Manual
Dynamic Brake				-
Position Control Mode		Max. Input Pulse Frequency		Line driver: Max. 500Kpps (low speed)/Max.4Mpps(high speed) Open collector: Max. 200Kpps
		Pulse Type		Pulse + Direction, A phase + B phase, CCW pulse + CW pulse
		Command Source		External pulse train
		Smoothing Strategy		Low-pass filter
		Electronic Gear		Electronic gear N/M multiple N: 1 ~ (2 26 -1)/M:1 ~ (2 31 -1) 1/50 < N/M < 25600
		Torque Limit Operation		Set by parameters
		Feed Forward Compensation		Set by parameters
Speed Control Mode		Analog Input Command	Voltage Range	0 ~ ±10 VDC
			Input Resistance	10 KΩ
			Time Constant	2.2 us
		Speed Control Range*1		1 : 5000
		Command Source		External analog signal /Internal parameters
		Smoothing Strategy		Low-pass and S-curve filter
		Torque Limit Operation		Set by parameters or via Analog input
		Responsiveness Characteristic		Maximum 550Hz
		Speed Fluctuation Rate *2(at rated speed)		0.01% or less at load fluctuation 0 to 100%
				0.01% or less at power fluctuation ±10%
				0.01% or less at 0 to 50 degree centigrade ambient temperature fluctuation
Torque Control Mode		Analog Command Input	Voltage Range	0 ~ ±10 VDC
			Input Resistance	10 KΩ
			Time Constant	2.2 us
		Command Source		External analog signal / Internal parameters
		Smoothing Strategy		Low-pass filter
		Speed Limit Operation		Parameter Setting or via Analog input
Analog Monitor Output				Monitor signal can set by parameters (Output voltage range: ±8 V)
Communication Interface				RS-232/RS-485

ASD-B2-0421-B external dimension (mm)