2PH 56mm NEMA23 1.5A 0.5NM 71ozin 24-48VDC Stepper motor Drive kits 2S56Q-02741+2M530

2PH 56mm NEMA23 1.5A 0.5NM 71ozin 24-48VDC Stepper motor Drive kits  2S56Q-02741+2M530

2S56Q-02741+2M530

Hybrid Servo Motor 2S56Q-02741

Specifications

Model	2S56Q-02741
Step Angle	1.8centigrade degree±5%
Phase Current (A)	1.5
Holding Torque (Nm)	0.5
Damping Torque (Nm)	0.02
Winding Resistance (ohm)	1.8±10%
Winding Inductance(mH)	4.1±20%
Motor Inertia (Kg.com²)	0.14
Motor Length L(mm)	41
Number of Lead Wires	4
Insulation Class	B
Withstand Voltage Level	500VAC,one minute
Max.Axial Load (N)	15
Max.Readial Load (N)	75
Operating Temperature	-20centigrade degree~50centigrade degree
Surface Temperature Rise	Max.80centigrade degree (Rated Phase Current after Two Phases are Connected)
Insulation Impedance	Minimum 100Mohm,500VDC
Weight (Kg)	0.42
Lead Wire Length (mm)	300±5

Hybrid Servo Drive 2M530

Features:

The Maximum Supply Voltage can Reach 40V, Which can Provide Better Dynamic Drive Performance;

The Bipolar Constant Current Drive Mode is Taken with a Maximum Drive Current up to 2.5A Per Phase, Which can Drive any Two-Phase Bipolar Hybrid Stepper Motors with a Current Less than 2.5A;

The Drive Output Phase Current of a Motor can be Regulated Through the DIP Switch, to Match Motors of Different Specifications;

A DIP Switch is Used to Set the Automatic Half Current Function of Motors in Statically Locked Status, which can Greatly Reduce Heat Dissipation of the Motors;

A Dedicated Control Chip is Used, with a Maximum of 256/200 Subdivisions. The Subdivision Function can be Set by the DIP Switch, to Ensure the Best Operation Stability;

Supporting Offline Function, So that the Output Current of a Motor can be Cut Off If Necessary;

Optical Coupling Devices are Used for the Isolation of the Input Circuit of the Control Signals to Reduce Interference of External Noises.

Specification

Model	2M530
Supply Voltage	DC 24V ~ 48V
Output Phase Current	1.2A~ 3.5A
Control Signal Input Current	6~16mA
Cooling Method	Natural Air Cooling
Operating Environment	Avoid the Environment with a Great Amount of Metallic Powder, Oil Mist, or Erosive Gases
Operating Temperature	-10centigrade degree~ +45centigrade degree
Operating Humidity	< 85% (Non-Condensing)
Weight	0.7 Kg