D4JL-4NFA-C7-01 Safety Door Switch NEW

D4JL-4NFA-C7-01 OMRON Safety Door Switch NEW

OMRON Safety Door Switch D4JL-4NFA-C7-01

Product Description:

World's Top* Holding Force of 3,000 N

Specifications:

Degree of protection *1		IP67 (EN60947-5-1)
Durability *2	Mechanical	1,000,000 operations min. (trapped key: 10,000 operations min., rear release button: 3,000 operations min.)
	Electrical	500,000 operations min. (3 A resistive load at 250 VAC) *3
Operating speed		0.05 to 0.5 m/s
Operating frequency		30 operations/minute max.
Direct opening force *4		60 N min. (EN60947-5-1)
Direct opening travel *4		15 mm min. (EN60947-5-1)
Holding force *5		3,000 N min.
Contact resistance		25 mΩ max. (per contact)
Minimum applicable load *6		1 mA resistive load at 5 VDC (N-level reference value)
Rated insulation voltage (Ui)		300 V (EN60947-5-1)
Rated frequency		50/60 Hz
Protection against electric shock		Class II (double insulation)
Pollution degree		3 (EN60947-5-1)
(operating environment)
Impulse	Between terminals	2.5 kV
withstand	of same polarity
voltage	Between terminals	4 kV
(EN60947-5-1)	of different polarity
	Between other	6 kV
	terminals and
	non-current carrying
	metallic parts
Insulation resistance		100 MΩ min. (at 500 VDC)
Contact gap		2 × 2 mm min.
Vibration	Malfunction	10 to 55 Hz, 0.75 mm single amplitude
resistance
Shock resistance	Destruction	1,000 m/s 2 min.
	Malfunction	80 m/s 2 min.
Conditional short-circuit current		100 A (EN60947-5-1) *7
Conventional free air thermal current (Ith)		10 A (between terminals 12 and 41),
		3 A (between all other terminals) (EN60947-5-1)
Ambient operating temperature		-10 to +55°C (with no icing)
Ambient operating humidity		95% max.
Weight		Approx. 650 g (D4JL-4NFA-C7-01)

Note:

*1.The degree of protection is tested using the method specified by the standard (EN60947-5-1). Confirm that sealing properties are sufficient for the operating conditions and environment beforehand. Although the switch box is protected from dust or water penetration, do not use the D4JL in places where foreign material may enter through the key hole on the head, otherwise Switch damage or malfunctioning may occur.

*2.The durability is for an ambient temperature of 5 to 35°C and an ambient humidity of 40% to 70%. For further conditions, consult your OMRON sales representative.

*3.Do not pass a 3 A, 250 VAC load through more than two circuits.

*4.These figures are minimum requirements for safe operation.

*5.This figure is based on the GS-ET-19 evaluation method.

*6.This value will vary with the switching frequency, environment, and reliability level. Confirm that correct operation is possible with the actual load beforehand.

*7.Use a 10 A fuse type gI or gG that conforms to IEC 60269 as a short-circuit protection device.