Delta Inverter VFD drive VFD015E23A 3Phase 220V 1.5KW 2HP 0.1~600Hz Grinding &Drilling machine

VFD015E23A

 

Features

Sensorless Vector AC Micro Drive. The VFD-E series represent Delta Electronics low horsepower, constant torque, IP20 rated Drive. Modular in design with flexible extension cards and a built-in PLC function, the E drive offers the ability to write and to execute simple Ladder Logic programs. This state-of-the-art series meets a full range of application requirements.

Specifications

?Output frequency: 0.1~600Hz

?Modular & compact design

?Built-in PLC function

?Built-in EMI filter (230V 1 phase / 460V 3 phase)

?Optional Fieldbus Modules (DeviceNet, Profibus, LonWorks and CANopen)

?RFI-switch for mains

?Easy DC BUS sharing

?Flexible extension

?Complete Protection

Applications

Smaller cranes; washing machines; treadmilsl; robot arm of injection machine (clamp); elevator; grinding machine; drilling machine; wood machine; webbing loom; air conditioner for large buildings; water supply system for large buildings, etc.

General Specifications

Control Characteristics	Control System		SPWM (Sinusoidal Pulse Width Modulation)Control (V/f or sensorless vector control)
	Frequency Setting Resolution		0.01Hz
	Outing Frequency Resolution		0.01Hz
	Torque Characteristics		Including the auto-torque/auto-slip compensation; starting torque can be 150% at 3.0Hz
	Overload endurance		150% of rated current for 1 minute
	Skip Frequency		Three zones, setting range 0.1~600Hz
	Accel/Decel Time		0.1 to 600 seconds (2 Independent setting of Accel/Decel time)
	Stall Prevention Level		Setting 20 to 250% of rated current
	DC Braking		Operation frequency 0.1~600.0Hz, output 0~100% rated current Start time 0~60 seconds, stop time 0~60 seconds
	Regenerated Braking Torque		Approx, 20% (up to 125% possible with optional brake resistor or externally mounted brake unit, 1-15hp models(built-in brake chopper)
	V/f Pattern		Adjustable V/f pattern
Operating Characteristics	Frequency Setting	Keypad	Setting by “UP” “Down”
		External Signal	Potentiometer-5k ohm / 0.5W, 0 to +10VDC, 4 to 20mA, RS-485 interface; Multi-function Inputs 3 to 9(15 steps, Jog, up/down)
	Operation Setting Signal	Keypad	Set by RUN and STOP
		External Signal	2 wires/3 wires (FWD, REV, EF), JOG operation, RS-485 serial interface(MODBUS), programmable logic controller
	Multi-function Input signal		Multi-step selection 0 to 15, Jog, accel/decal inhibit, 2 accel/decal switches, counter, external Base Block (NC,NO), axxiliary motor control is invalid, ACI/AVI/AUI selections, driver reset, UP/DOWN key setting, sink/source(-NPN/PNP) selection
	Multi-function Output Indication		AC drive operating, frequency attained, non-zero frequency, Base Block, fault indication, local/remote, indication, auxiliary motor output, drive is ready, overheat alarm, emergency stop and status selections of input terminals(NC/NO)
	Analog Output Signal		Output frequency/current
Alarm Output Contact			Contact will be On when drive malfunctions (1 Form C/Change-over contact or 1 open collector output)
Operation Functions			Built-in PLC, AVR, accel/decal S-Curve, over-voltage/over-current stall prevention, 5 fault records, reverse inhibition, momentary power loss restart, DC braking , auto torque/slip compensation, auto tuning, adjustable carrier frequency, output frequency limits, parameter lock/reset, vector control, PID control, external counter, MODBUS communication, abnormal reset, abnormal re-start, power-saving, sleep/wake function, fan control 1st/snd frequency source selections, 1st/2nd frequency source combination.
Protection Functions			Over voltage, over current, under voltage, under current, external fault, overload, ground fault over heating, electronic thermal, IGBT short circuit, PTC
Display Keypad			6-key, 7-segment LED with 4-digit, 5 status LED, master frequency, output frequency, output current, custom units, parameter values for setup and lock, faults, RUN/STOP/RESET,FWD/REV
Built-in EMI Filter			For 230V 1-phase and 460V 3-phase models
Environmental Conditions	Enclosure Rating		IP20
	Pollution Degree		2
	Installation Location		Altitude 1,000m or lower, keep from corrosive gasses, liquid and dust
	Ambient Temperature		-100C to + 500C (400C for side-by-side mounting) Non-Condensing and not frozen
	Storage/Transportation Temperature		-200C + 600C
	Ambient Humidity		Below 90% RH (non-condensing)
	Vibration		9.80665m/s2(1G) less than 20Hz, 5.88m/s2 (0.6G) at 20 to 50Hz

Detailed Specifications

Diagram 1

Voltage Class		115V
Model Number VFDXXXE		002	004	007
Max. Applicable Motor Output (kW)		0.2	0.4	0.75
Max. Applicable Motor Output (hp)		0.25	0.5	1.0
Output Rating	Rated Output Capacity (kVA)	0.6	1.0	1.6
	Rated Output Current (A)	1.6	2.5	4.2
	Maximum Output Voltage(V)	3-phase proportional to twice the input voltage
	Output Frequency(Hz)	0.1~600Hz
	Carrier Frequency(kHz)	1-15
Input Rating	Rated Input Current(A)	Single-phase
		6	9		18
	Rated Voltage/Frequency	Single phase 100-120V, 50/60Hz
	Voltage Tolerance	+-10%(90-132V)
	Frequency Tolerance	+-5%(47-63Hz)
Cooling Method		Natural Cooling			Fan Cooling
Weight(kg)		1.2	1.2		1.2

Diagram 2

Voltage Class		230V
Model Number VFDXXXE		002		004		007		015		022		037		055			075		110		150
Max. Applicable Motor Output (kW)		0.2		0.4		0.75		1.5		2.2		3.7		5.5			7.5		11		15
Max. Applicable Motor Output(hp)		0.25		0.5		1.0		2.0		3.0		5.0		7.5			10.0		15		20
Output Rating	Rated Output Capacity(kVA)	0.6		1.0		1.6		2.9		4.2		6.5		9.5			12.5		17.1		25
	Rated Output Current(A)	1.6		2.5		4.2		7.5		11.0		17		25			33		45		65
	Maximum Output Voltage(V)	3-phase proportional to input voltage
	Output Frequency(Hz)	0.1~600Hz
	Carrier Frequency(kHz)	1-15
Input Rating	Rated Input Current(A)	Single/3-phase									3-phase
		4.9/1.9	6.5/2.7		9.7/5.1		15.7/9		24/15		20.6		26		34			48		70
	Rated Voltage/Frequency	Single/3-phase, 200-240V, 50/60Hz									3-phase, 200-240V, 50/60Hz
	Voltage Tolerance	+-10% (180-264V)
	Frequency Tolerance	+-5%(47-63Hz)
Cooling Method		Natural Cooling									Fan Cooling
Weight(kg)		1.1	1.1		1.1		1.9		1.9		1.9		3.5			3.5		3.57		6.6

Diagram 3

Voltage Class		460V
Model Number VFDXXXE		004	007			015		022		037		055		075			110		150		185	220
Max. Applicable Motor Output (kW)		0.4	0.75			1.5		2.2		3.7		5.5		7.5			11.0		15		18.5	22
Max. Applicable Motor Output(hp)		0. 5	1.0			2.0		3.0		5.0		7.5		10.0			15.0		20		25	30
Output Rating	Rated Output Capacity(kVA)	1.2	2.0			3.3		4.4		6.8		9.9		13.7			18.3		24		29	34
	Rated Output Current(A)	1.5	2.5			4.2		5.5		8.5		13.0		18.0			24.0		32		38	45
	Maximum Output Voltage(V)	3-phase proportional to input voltage
	Output Frequency(Hz)	0.1~600Hz
	Carrier Frequency(kHz)	1-15
Input Rating	Rated Input Current(A)	3-phase
		1.9		3.2	4.3		7.1		11.2		14		19		26			35		41		49
	Rated Voltage/Frequency	3-phase, 380-480V, 50/60Hz
	Voltage Tolerance	+-10% (342-528V)
	Frequency Tolerance	+-5%(47-63Hz)
Cooling Method		Natural Cooling									Fan Cooling
Weight(kg)		1.2		1.2	1.2		1.9		1.9		4.2		4.2			4.2		7.47		7.47		7.47

Dimensions

 

Wiring Diagram