FX2N-10PG Mit 1mHZ pulse output module NEW

FX2N-10PG Mit 1mHZ pulse output module NEW

Introduction

FX -10PG Pulse Output Block (hereafter abbreviated as FX -10PG, Pulse Output Block or2N 2NPGU) is a special block to output a maximum 1MHz pulse array and drive single-axis stepping motor or servo motor. 

1)FX2N-10PG controls the positioning operation of one single-axis stepping motor or servmotor per unit.

2)FX2N/2NC or FX  Series PLC is connected to read and write the data with FROM/TO commands.

3)A pulse array of max. 1MHz can be output. (Differential line driver output)

Performance Specifications

Item	Specifications
Number of Control Axes	One axis per unit (Max. 8 units and 4 units can be connected to FX2NSeries PLC and FX2NC Series PLC respectively.)
Speed command	The operation speed is set with the buffer memory. It can be operated at the pulse frequency of 1Hz to 1MHz. Hz, cm/min, 10 deg/min and inch/min are selectable for the command unit.
Position command	The travel is set with the buffer memory. The pulse converted value is in the range of -2,147,483,648 to 2,147,483,647. Pulse, mm, mdeg and 10-4 inch are usable for the unit. The absolute position instruction and relative position instruction are selectable. The magnification rates of 100, 101 , 102 and 103 are settable for the position data.
Positioning program	Positioning is done in the PLC program. (Data read-/writing and operation mode selection are instructed with FROM/TO commands.)
Number of I/O Occupied points	8 points (Input or output.)
Start time	1 to 3ms

Applicable PLC

Series Name	Applicable version
FX2N Series	All versions
FX2NC Series	All versions

Dimension