PLC AC220V 8 DI 8 DO transistor Motion controller Delta DVP20PM00DT New

DVP20PM00DT Delta PLC 100-240VAC DI8 DO8 Motion controller Original brand new

Features

The advanced PM series motion control MPU can become the motion extension module of another PM series MPU, very flexible in all kinds of applications.

Specifications

*MPU points: 16 
*Max. I/O points: 512 
*Program capacity: 64K Steps 
*Communication port: Built-in RS-232 and RS-485, compatible with MODBUS ASCII / RTU communication protocol. 
*Data register: 10,000 words (latched) 
*500KHz high-speed pulse output: 
Built-in 2 groups of A/B phase differential signal ouput 
X-axis pulse output: (FP0+, FP0-), (RP0+, RP0-) 
Y-axis pulse output: (FP1+, FP1-), (RP1+, RP1-) 
*Supports Manual Pulse Generator (MPG) and multi-point external signal inputs

Power supply voltage	100 to 240 VAC (-15 to 10%), 50/60Hz ± 5%
Fuse capacity	2A/250 VAC
Power consumption	60 VA
DC24V current output	500 mA
Power protection	DC24V; output short-circuited
Withstand voltage	1,500 VAC (Primary-secondary); 1,500 VAC (Primary-PE); 500 VAC (Secondary-PE)
Insulation impedance	> 5M Ohm (all I/O point-to-ground 500 VDC)
Noise immunity	ESD: 8 kV Air Discharge, EFT: Power Line: 2 kV, Digital I/O: 1 kV, Analog & Communication I/O: 250 V
Grounding	The diameter of grounding wire shall not be less than that of L, N terminal of the power. (When many PLCs are in use at the same time, please make sure every PLC is properly grounded.)
Operation/storage	Operation: 0 to 55°C (temperature), 50 to 95% (humidity), pollution degree 2 Storage: -25 to 70°C (temperature), 5 to 95% (humidity)
Vibration/shock immunity	International standards: IEC61131-2, IEC 68-2-6 (TEST Fc)/IEC61131-2 & IEC 68-2-27 (TEST Ea)
Weight (g)	696

Applications

Used for 2-axis servo positioning control, material cutting machine (high-speed servo control), crane operations, material clipper controlled by the servo.