3PH 85mm NEMA34 5.8A 4NM 571ozin 24-40VDC Stepper motor Drive kits 3S85Q-04097+3M458

3PH 85mm NEMA34 5.8A 4NM 571ozin 24-40VDC Stepper motor Drive kits  3S85Q-04097+3M458

3S85Q-04097+3M458

Hybrid Servo Motor 3S85Q-04097

Specifications

Model	3S85Q-04097
Step Angle	1.2centigrade degree±5%
Phase Current (A)	5.8
Holding Torque (Nm)	4
Damping Torque (Nm)	0.12
Winding Resistance (ohm)	1.1±10%
Winding Inductance(mH)	4.6±20%
Motor Inertia (Kg.com²)	2.32
Motor Length L(mm)	97
Number of Lead Wires	6
Insulation Class	B
Withstand Voltage Level	600VAC 1S 5mA
Max.Axial Load (N)	60
Max.Readial Load (N)	220
Operating Temperature	-20centigrade degree~50centigrade degree
Surface Temperature Rise	Max.80centigrade degree(Rated Phase Current after Phases are Connected)
Insulation Impedance	Minimum 100Mohm,500VDC
Weight (Kg)	2.7

Hybrid Servo Drive 3M458

Features:

The AC Servo Drive Principle is Used,Providing AC Servo Rotation Characteristics and Three-Phase Sine Wave Current Output;
The Internal Drive DC Voltage Reaches 40V,Which can Provide Better High-Speed;
Supporting Automatic Half Current Function of Motors in Statically Locked Status, which can Greatly Reduce Heat Dissipation of the Motors;
Supporting Subdivision Function up to 10,000 Steps/Revolution. The Subdivision Function can be Set by the DIP Switch, to Ensure the Best Operation Stability;
It has Little the Resonance and Creeping Area Common to Stepper Motors.The Output Phase Current can be Set through the DIP Switch,Featuring Very Low Operation Noise,Closing to the AC Servo Level.
Optical Coupling Devices are Used for the Isolation of the Input Circuit of the Control Signals to Reduce Interference of External Noises. 
The Sine Current Drive Mode is Taken So that the No-Load Start Frequency of a Motor can Reach about 5KHz(100Steps/Revolution). 

Specification

Model	3M458
Supply Voltage	DC 24V ~40V
Output Phase Current	3A~ 5.8A
Control Signal Input Current	6~16mA
Cooling Method	Natural Air Cooling
Operating Environment	Avoid the Environment with a Great Amount of Metallic Powder, Oil Mist, or Erosive Gases
Operating Temperature	-10centigrade degree~ +45centigrade degree
Operating Humidity	< 85% (Non-Condensing)
Weight	0.7 Kg