M415B 20 28 42mm stepping motor 64 microstep driver 2ph DC18-40V 1.5A CNC

M415B 

Feature:

High performance, low price

Voltage supply: 18~40VDC

Drive current: 0.21~1.5A

Automatic half flow function

The highest dynamic 64 microstep

Photoelectric isolation signal input

Motor noise optimization function

Bipolar constant current chopping mode

Chopper frequency up to 100 KHZ

Exquisite shape, ease of installation

This drive only supports common anode connection, active low. Customers choose carefully!

Application:

Typical applications for AC stepper motor drive: Marking machine, labeling machine, cutting machine, plotter, small engraving machine, NC machine tools, transmission mechanism, medical apparatus and instruments, etc. For the vibration of the motor itself, the output torque of noise and its accuracy and high speed have been improved obviously.

Specification:

Item	Min	Typical	Max	Unit
Power supply	18	24	40	V
Average output current	0.21	1	1.5	A
Logic input current	6	15	30	mA
Impulse response frequency	-	-	100	KHZ
Pulse low level	5	-	1	μS

Current setting

PK Current	SW1	SW2	SW3
0.21A	off	on	on
0.42A	on	off	on
0.63A	off	off	on
0.84A	on	on	off
1.05A	off	on	off
1.26A	on	off	off
1.50A	off	off	off

Subdivision setting:

MSTEP	SW4	SW5	SW6
1	on	on	on
2	off	on	on
4	on	off	on
8	off	off	on
16	on	on	on
32	off	on	off
64	on	off	off

Wiring Description

Signal	Function
PUL	Pulse signal: rising edge, the pulse from low to high is to go a step angle motor
DIR	Direction signal: TTL-level driver to change the direction
OPTO	Optocoupler drive power
ENA	Enable signal: block or allow the drive to work, low-level ban
GND	DC power supply ground
+V	DC power supply positive (typical 24VDC)
A+	Motor Phase A
A-	Motor Phase A
B+	Motor Phase B
B-	Motor Phase B

Wiring Diagram

NOTE: when VCC voltage is +5V, Without series resistor R ,R=0 ohm;

when VCC voltage is +12V, ,R=1k ohm/0.25w

when VCC voltage is +24V, ,R=1k ohm/0.25w