2ph 86mm NEMA34 110mm NEMA42 130mm NEMA52 motor Stepper drive ND2282 90-220VAC 0.7-8.2A Leadshine New

2ph 86mm NEMA34 110mm NEMA42 130mm NEMA52 motor  Stepper drive ND2282 90-220VAC 0.7-8.2A Leadshine New ND2282 The ND2282 is a high performance and low noise microstepping driver based on pure-sinusoidal current control technology. It’s suitable for driving 2-phase and 4-phase hybrid stepping motors. By using advanced bipolar constant-current chopping technique, the ND2282 can output more torque than other drivers at high speed. The microstep capability allows stepping motors to run at higher smoothness, less vibration and lower noise. Its pure-sinusoidal current control technology allows coil current to be well controlled with relatively small current ripple, therefore smaller motor noise and less motor heating can be achieved. In addition, the ND2282 has a built-in EMI filter which can make the driver operate with higher reliability. Features High quality, cost-effective Low motor noise and heating Supply voltage up to 220VAC (310VDC) Output current up to 8.2A(5.86 ARMS) TTL compatible and Opto-isolated inputs Automatic idle-current reduction Input frequency up to 200KHz 15 microstep resolutions selectable Suitable for 2-phase and 4-phase stepping motors DIP switch microstep & current settings Support PUL/DIR & CW/CCW modes Specifications Parameters ND2282 Min Typical Max Unit Output current 0.7(0.5A RMS) - 8.2 (5.86 RMS) A Supply voltage 90(125) 180(250) 220(310) VAC(VDC) )Logic signal current 7 10 16 mA Pulse input frequency 0 - 200 kHz Isolation resistance 500 - - Mohm