10PCS LJ18A3-8-Z-AX Inductive Proximity Sensor Switch For Relay M18 DC6-36V 8mm

Cylinder type, can be the direct substitution of the same type both at home and abroad

Power supply reversal connection protection; short-circuit protection, can directly connect with PLC.

Used in common places with medium environment resitance.

Red led indicates that it is available to detect the sensor operating state.

Economic and simple operation.

Widely used, can be the substitution of min-type switch and limiting switch.

IP67 protection structure(IEC specification).

Read the Matters needing attention of the product instruction before use.

Dimension				M18(LJ18)
Mounting way				Screen shield type	Non-Screen shield type
Type	DC type	NPN	NO	LJ18A3-5-Z/BX	LJ18A3-8-Z/BX
			NC	LJ18A3-5-Z/AX	LJ18A3-8-Z/AX
			No+NC	LJ18A3-5-Z/CX	LJ18A3-8-Z/CX
		PNP	NO	LJ18A3-5-Z/BY	LJ18A3-8-Z/BY
			NC	LJ18A3-5-Z/AY	LJ18A3-8-Z/AY
			NO+NC	LJ18A3-5-Z/CY	LJ18A3-8-Z/CY
		Two-wire	NO	LJ18A3-5-Z/EX	LJ18A3-8-Z/EX
			NC	LJ18A3-5-Z/DX	LJ18A3-8-Z/DX
	AC type	Two-wire	NO	LJ18A3-5-Z/EZ	LJ18A3-8-Z/EZ
			NC	LJ18A3-5-Z/DZ	LJ18A3-8-Z/DZ
		Three-wire	NO+NC
Detection distance				5mm(+10%~-10%)	8mm(+10%~-10%)
Set distance				0~4mm	0~7mm
Standard detection object				Iron 18*18*1mm	Iron 30*30*1mm
Response frequency				DC:0.5KHz AC:25Hz	DC:0.5KHz AC:25Hz

Delay distance: 10% below of the detection distance

Detection object: Magnetic metal(the detection distance decreases when ti is non-magnetic metal)

Suppply voltage: DC type D12-24V(6~36V)impulse (p-p)10% below, AC type AC110~220V (36~250V)50/60Hz

Consumption current: N.p type: 13mA below, D type:0.8mA below, A type:1.7mA below

Control output: N.p type: 300mA below, D type:200mA below, A type:400mA below

Loop protection: N.P.D type: reversal connection protection, surge absorption, load short-circuit protection, A type: surge absorption.

Material: (Housing: Nickel plated brass), (Detection surface: ABS)