TL-Q5MB1-Z Proximity Sensor NEW

TL-Q5MB1-Z Omron Proximity Sensor NEW

roduct Description and Specifications:

Technical characteristics

 

 • TL-N / TL-Q / TL-G is the inductive proximity sensor

 • Sensing distance: 5 ... 20 mm

 • The sensor type is not covered

 • Frequency response: DC 40 ... AC 10Hz or 500 Hz max.

 • Supply voltage: 12-24 VDC

 • Connectivity: Wireless connectivity is available, DC 2 - wire or 3-wire DC or 2-wire AC

 • Control output: current 0 ... 100mA

 • outputs: NPN / PNP, NO / NC

Type	Unshielded
Sensing method	Inductive type
Sensing distance	5 mm -10% to +10%
Setting distance	0 to 4 mm
Differential distance	10% Max. of sensing distance
Sensing object	Ferrous metal (Sensitivity lowers with non-ferrous metals.)
Standard sensing object	Iron 15*15*1mm
Response frequency	DC: 500 Hz (average)
Response time	2 ms Max.
Power supply voltage	12 to 24 VDC (ripple(p-p) :10% Max.)
Operating voltage range	10 to 30 VDC
Current consumption	10 mA Max. (at 24VDC)
Control output (Output type)	PNP open collector output
Control output (Switching capacity)	0 to 50 mA (at 30VDC)
Control output (Residual voltage)	(DC) 1 V Max. ?under load current with cable length of 2m?
Indicator	Detection indicator(red)
Operation mode	NO
Protective circuit	Surge suppressor Power supply reverse polarity protection
Standard or Different frequency	Standard
Ambient temperature	Operating: -25 to 70 CEL Storage: -25 to 70 CEL (with no icing or condensation)
Ambient humidity	Operating: 35 to 95 %RH Storage: 35 to 95 %RH (with no condensation)
Temperature influence	+-20% Max. of sensing distance in temperature range of -25 to +70CEL (As the basis for sensing distance of 23CEL)
Voltage influence	+-2.5% Max. of sensing distance in rated voltage range +-10%. (As the basis for sensing distance at standard power voltage)
Insulation resistance	5 M OHM Min. at 500VDC between charged parts and the case
Dielectric strength	500 VAC 50/60 Hz for 1 minute between charged parts and the case
Vibration resistance	10 to 55 Hz, 1.5-mm double amplitude for 2 hours each in X, Y, and Z directions
Shock resistance	200m/s2 for 10 times each in X, Y, and Z directions
Degree of protection	IEC60529: IP67
Applicable standard (EC Directive (Low Voltage Directive))	EN60947-1 EN60947-5-2
Applicable standard (EC Directive (EMC Directive))	EMI: EN60947-5-2 Emission Enclosure: CISPR11 Group 1 class A EMS: EN60947-5-2 Immunity ESD: IEC61000-4-2 Immunity RF-interference: IEC61000-4-3 Immunity Conducted Disturbance: IEC61000-4-6 Immunity Burst: IEC61000-4-4 CE marking: Equipped
Applicable standard (CCC mark)	Not equipped
Connection method	Pre-wired models (Cable length: 2 m)
Weight (Packed state)	approx. 60 g
Material (case)	Heat-resistant ABS resin
Material (sensing surface)	Heat-resistant ABS resin
Accessories	Not equipped