E2EZ-X4C1 Chip-immune Inductive Proximity Sensor NEW

E2EZ-X4C1 Omron Chip-immune Inductive Proximity Sensor NEW

Product Description:

DC 3-Wire Model , Shielded , M18 , Sensing Distance 4mm , Operation Mode NO.

Specifications:

Cylinder type sensing head size	M18
Type	Shielded
Sensing method	Inductive type
Sensing distance	4 mm -10% to +10%
Setting distance	0 to 3.2 mm
Differential distance	20% Max. of sensing distance
Sensing object	Ferrous metal (Sensitivity lowers with non-ferrous metals.)
Standard sensing object	Iron 30*30*1mm
Response frequency	DC: 12 Hz (average)
Power supply voltage	12 to 24 VDC (ripple(p-p) :10% Max.)
Operating voltage range	10 to 30 VDC
Current consumption	15 mA Max.
Control output (Output type)	NPN open collector output
Control output (Switching capacity)	0 to 100 mA (at 12VDC)
	0 to 200 mA (at 24VDC)
Control output (Residual voltage)	(DC) 2 V Max. ?under load current with cable length of 2m?
Indicator	Detection indicator(red)
Operation mode	NO
Protective circuit	Surge suppressor
	Output short-cut protection
	Power supply reverse polarity protection
Standard or Different frequency	Standard
Ambient temperature	Operating: 0 to 50 CEL
	Storage: 0 to 50 CEL
	(with no icing or condensation)
Ambient humidity	Operating: 35 to 95 %RH
	Storage: 35 to 95 %RH
	(with no condensation)
Temperature influence	+-20% Max. of sensing distance in temperature range of 0 to +50CEL
	(As the basis for sensing distance of 23CEL)
Voltage influence	+-2.5% Max. of sensing distance in rated voltage range +-10%. (As the basis for sensing distance at standard power voltage)
Insulation resistance	50 M OHM Min. at 500VDC between charged parts and the case
Dielectric strength	1000 VAC 50/60 Hz for 1 minute between charged parts and the case
Vibration resistance	10 to 55 Hz, 1.5-mm double amplitude for 2 hours each in X, Y, and Z directions
Shock resistance	1000m/s2 for 10 times each in X, Y, and Z directions
Degree of protection	IEC60529: IP67
	Company standard: Oil-proof
Applicable standard (EC Directive (Low Voltage Directive))	EN60947-1
	EN60947-5-2
Applicable standard (EC Directive (EMC Directive))	EMI: EN60947-5-2
	Emission Enclosure: CISPR11 Group 1 class A
	EMS: EN60947-5-2
	Immunity ESD: IEC61000-4-2
	Immunity RF-interference: IEC61000-4-3
	Immunity Conducted Disturbance: IEC61000-4-6
	Immunity Burst: IEC61000-4-4
	CE marking: Equipped
Applicable standard (CCC mark)	Not equipped
Connection method	Pre-wired models (Cable length: 2 m)
Weight (Packed state)	approx. 170 g
Material (case)	Brass nickel plating
Material (sensing surface)	Heat-resistant ABS resin
Material (clamping nuts)	Iron zinc plating
Material (toothed washer)	Iron zinc plating
Accessories	Instruction manual